Home Detailed application Diamond Trim Application E280 - Trim Application

E280 - Trim Application

Application Instructions

E280 is used both to create expansion joints on large roofs (over 50m2), create rolls on any ridge details and can be used to bridge GRP to felt roofs. It is compatible with C5 closures. An adequate gap in the deck should be cut if necessary, the trim should then be nailed to each end of the decking at 300mm centres. The join over the nails should then be bandaged and the laminate can be applied over the trim. To bond these trims together, or to cap with C5 closures, apply a thin strip of Diamond Trim adhesive to the inside edge of the overlapping trim and rub into place.

The E280 can also be used to bridge between a GRP and adjoining felt roof. The E280 should be fixed to the decking at the end of the GRP roof taking up the felt at the edge if possible to lay the trim underneath. The felt should either be bonded to the trim with a liberal coating of Topflex acrylic roof coating both under and over the felt layer. Alternatively, a torch-on strip can be used over the joint as the edge trim profiles are flame resistant. This should be completed before the laminate is laid over the other edge of the trim.

Trim Details

E280: Expansion joint and ridge roll for pitched roofs.



  a, mm b, mm
E280 200 60

E280 bridge to adjoining felt roof



We use cookies to improve our website and your experience when using it. Cookies used for the essential operation of the site have already been set. To find out more about the cookies we use and how to delete them, see our privacy policy.

I accept cookies from this site.
EU Cookie Directive plugin by www.channeldigital.co.uk